Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Body - Exterior> orange peel, long sorry!!
User Name
Password
lost password?   |   register now

Thread: orange peel, long sorry!! Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
08-08-2012 08:30 PM
JCAR thank you, JCAR
08-07-2012 12:32 AM
4inthefloor are u useing a hvlp gun? if so spray the window (thats taped up) first to make sure your spraying an even fan. turn the amount of paint that is coming out of the gun down and give a longer flash time between coats ( i usally smoke a cig between coats and get back after it ) 12-15 psi at the gun with hvlp about 25-30 with a cup gun. then adjust it by ear with the regular on your gun till it sounds right
07-29-2012 05:31 PM
JCAR
orange peel, long sorry!!

I know peel has been covered many times, and I am sorry for bringing it up again, but I am not sure what to do about my specific challenge. Long story short is, I laid the clear on the flat areas like the hood and roof just fine ( or at least good enough for me !!), but i peeled the vertical surfaces. I also had a couple "flow indicators" in the vertical surfaces. I am guessing air pressure too low? It's a pick up and I still have the bed to clear, using water- base base coat, not under any time constraints, and I don't want to make the same mistake. The peel is not real bad, I am sure it will cut and buff, but I must be doing something different on the vertical surfaces? Any help or suggestions are appreciated, thank you Jcar

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 06:43 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.