Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Hotrodding Basics> Rearend set up.......?
User Name
Password
lost password?   |   register now

Thread: Rearend set up.......? Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
10-06-2012 03:37 PM
64 elky Yeah that's true I would have the drive shaft made last due to the fact that the length may change once the full waleight is set on the chassis.
10-06-2012 03:06 PM
V8Square
Driveshaft angle

I also have a rear end question (as this is my first project like this and I have many questions). I, too, have a 4 bar adjustable rear end in my narrowed 9" Ford. From my transmission tail shaft, to my rear end, what is the permissable degree the driveshaft van be without any problems? This car is for street use only. Also, currently, I do not have my body on my chassis and was advised that it should be mounted before a driveshaft is made. That is, do not have the driveshaft made until all the weight is on the chassis. Help Please!!! By the way, here are some pictures of my setup.













10-06-2012 01:46 PM
ssimpala I would start at -4. Mine did best at -2. Bill.
10-06-2012 11:23 AM
64 elky
Rearend set up.......?

On an "A-body" application 4-link set up with tubular adjustable top and bottom bars. What would be my starting point for a drag application. -6degrees? Or only -4degrees? (Because I have only about 440hp. With a 28" tall tire with 4.10gear.)

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 03:32 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.