|10-13-2012 08:16 PM|
Well they unbolt from the Volare but are then welded in. At least all I have seen have the frame rails cut to shape then welded in.
I really had my hopes up. It would have been a great way to raise it. It looks like my only hope is some custom fabbed raised spindles. It looks like there are a few shops that do this kind of work but it looks like most of them want to do the same spindles they have been doing.
|10-13-2012 07:31 PM|
volare to truck swap,
I looked at a early 50's truck a while back, got down and looked under it and the guy said it unbolted, for the truck swap he trimmed the crossmember, I just checked the ford truck forum and they go thru a list of Mopar swaps into ford trucks,
|10-13-2012 12:50 PM|
timothale, I'll have to look at my manual too see but i think its welded in.
MARTINSR, they still make raised spindles for a lot of trucks on the market. It looks like I might have to find a good welder. Its probally a little more than I want to tackel with my stick welder LOL
|10-13-2012 11:17 AM|
They can be cut and welded but you better have a QUALIFIED welder weld them!
|10-13-2012 09:47 AM|
Doesn't the Volarie have a bolt in crossmember, put some spacers between the frame structure and the crossmember.
|10-12-2012 06:10 PM|
Volare spindles.... raised?
Anyone know if you can buy raised volarie spindles anywhere? Or can they be cut and rewelded? The torsion bars are cranked up as high as I feel comfortable going.