|10-15-2012 01:20 PM|
Here's some i found. If you had a picture it would help. There's a ton of clamp-like fasteners on the homedepot site. Just put clamp in the search bar.
What about a hose clamp?
If you can get a picture I could help you better
|10-15-2012 01:13 PM|
I have thought about trying to weld it, but i do not have a welder that will join brass and aluminum. I have an idea to use the mount holes on the side of the tranny and make a backing plate for the cable to prevent it from moving backwards. It will go from P - D but will not go back up into P because of it free moving.
Now if I were to try and use the clamp you have seen at hardware store, can you find a name or a picture that I can refer to?
|10-13-2012 08:22 PM|
|bigdog7373||I'm not completely sure what you're asking but i know i've seen something like what you're asking about at hardware stores. Why dont you heat it up, move it to where you need it, then weld it? WOuld be a lot more secure.|
|10-13-2012 01:00 PM|
More Shifter Cable Bracket ?'s
So I eneded up getting a cable bracket - Picutre below - and it mounts up to the pan bolts. Now I got a cable - Picture Below - for a 77' camaro with a th350 and sbv8. I managed to get it to mount to the shifter just fine, but the hole on the bracket it too small to fit the cable through inbetween the bushings. I have vice gripped them together just to see if I would have enough range to shift the gears, and it works. I need some kind of C-Clamp fastener that will hold them together. Does any one know of the best route to go about this? Do they make c clamp hardware not designated for using it as a tool?