|10-24-2012 07:30 PM|
|10-24-2012 06:50 PM|
|10-24-2012 05:09 PM|
|10-24-2012 03:41 PM|
|rbutler||Nice clean install. Looks much cleaner and stout than trans line method.|
|10-22-2012 03:46 PM|
|10-22-2012 02:23 PM|
That bung that you installed to your pan for the sending unit, is it just sealed by compression with rubber gaskets?
|10-22-2012 01:12 PM|
This is where mine is located and as far as I'm concerned, close enough for anything I'm doing with my car (trans. temp. runs within a couple degrees of the engine coolant temp (175-180 on a 90 degree day):
|10-22-2012 12:28 PM|
|sedanbob||Most aftermarket trans temp gauges I have seen put the sending unit on a tee fitting plumbed into the trans oil cooler line. This link shows the kit from B&M: B&M Automotive B&M Trans Temp Gauge Kit - Transmission Temp Gauge - Gauges & Mounting Kits - Interior Parts & Accessories - by 4 Wheel Parts|
|10-22-2012 10:42 AM|
Transmission temp gauge sending unit
I would like to know where the best location to install a temperature sending unit for the transmission is and why?
If it matters the transmission I would be installing it into is a th400