Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Electrical> turn key, no crank
User Name
Password
lost password?   |   register now

Thread: turn key, no crank Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
10-25-2012 05:20 PM
vicrod
clean

X2 on clean the battery cable connections. Better yet replace the battery cables. Unseen corrosion can occur inside the terminal lugs which can cause the problem you describe.

vicrod
10-25-2012 03:27 PM
boothboy Do all the things suggested, there all good. The next time it does it stop trying to start it. Get some one to hold the key in the start position and tap the starter with a hammer . If it starts replace the starter. If not back to square one. I would also clean the battery terminals. It can't hurt and can also cause intermittent starting. Don't take anything for granted.
BB
10-25-2012 03:18 PM
S10 Racer Check all starter connections for tight with no corrosion and make sure you have a good ground. You should have a ground to the engine from the battery and a ground from the engine to the chassis and ground from engine or chassis to the body (you can't have too many grounds IMO). It could also be the ignition switch or neutral safety switch going South.
10-25-2012 03:10 PM
E.Furgal it's a mopar, check the ballast..
10-25-2012 03:01 PM
Lounct
turn key, no crank

66 Dodge Cornet 318 ..Came home from a car show, parked in the driveway,, went out to put car away turned key, starter di not engage, had good juice to lights and radio, tried a few more times. moved shiifter (automaic on cloumn) into nuetral, nothing I must have tried ten times..Came back in ten minuted car started , and started 20 more time over next five days, it did it again, then when I put the test on the small nut on starter , car cranked, and again three days ago,.,,,seemes like when it does it, and i go to test it , im gronding the small nut to the chassis ,,All conections are tight & battery test full.. Oh, and I did replace the starter three months ago, when we installed mopar electronic ignition kit, wit the new ballast, and small box that goes on the fire wall.. I drove the car 600 miles no issues .so this is Russian Roulette if i go out,,,I have the car on jackstands so when it does it, i can go right under the car.....any ideas????PLEASE

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 10:33 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.