|11-09-2012 05:14 PM|
Won't comment on the appropriateness of DP's and headwork.........
But here's "probably" the fastest way to get started on fixturing.Starting with this and then snag a cpl right angle plates.
Atlas Craftsman 6" 618 101 Lathe Bed Model No 101 21200 | eBay
|11-06-2012 04:13 PM|
Cylinder head fixture for Drill Press
I have been modifying a couple heads here and there for screw in studs and larger springs and higher valve lifts. I was wondering if you guys have any good ideas on building a fixture that will allow me to do this on the drill press. I have been doing them with a variable speed corded drill and im just looking at a more efficient way to do these and also I can do it with a consistent speed and pressure if i do it with a drill press. Im looking at something that I can bolt to the table and fasten a head to it. 99.9% of what I do is SBC so I will build it for that.
Any ideas on what is available out there on the market for me to maybe purchase directly? I can make it but If I can find something like this already built for a reasonable price it will probably be worth it.