Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Suspension - Brakes - Steering> how to properly center a rear end
User Name
Password
lost password?   |   register now

Thread: how to properly center a rear end Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
11-10-2012 09:11 PM
Supercharged03
Centering a rear end

Just today, I read an article in the Dec 2012 Car Kulture Deluxe magazine that described installing a Nova rear end in a 51 Chevy. Basically, they took the centerline between the frame rails, hung a plumb bob at that point, and lined up the rear end with the bob. They clamped the spring pads in place and postponed welding them until the body was set back on the frame and the ride height was set. This allows the spring perches to be welded in place with the proper 2 degree offset angle for the driveshaft.
11-10-2012 07:56 PM
Fairlane Man
how to properly center a rear end

OK I have a 63 Fairlane. It was upgraded to a V8 and now I have a 9" to replace the old weak "stocker". The problem is I need to weld on new spring pads to the 9" and need to know how to center it properly. I have some good ideas but would like to hear what has worked in the past? FYI, I did write down the measurments of the old "Stocker" but they got wiped off the white board.


Thanks

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 04:12 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.