Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Transmission - Rearend> T56 bellhousing alignment
User Name
Password
lost password?   |   register now

Thread: T56 bellhousing alignment Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
11-15-2012 07:09 AM
AutoGear Contact Browell and see if they have anything for your situation. Browell Bellhousing Custom Builds Aluminum and Steel Bellhousings

If you're doing anything seriously high performance, you'll want something more robust than the factory clutch cover. Or a blanket.
11-14-2012 01:08 PM
MerkXRTurbo
T56 bellhousing alignment

Hey all,
I'm adapting an LS1 T56 with stock bellhousing to an unusual engine choice using a homemade adapter plate. I need to align the bellhousing to the engine to make sure my crank and input shaft center lines are within spec of one another. This is usually a pretty straight forward process, except for the fact that the T56 bell doesn't have a nice round hole in the back like most bellhousings do.

Any ideas? The only two options that I can see are:

1: Source a Chevy bellhousing with a round hole in the back and trust that the factory's quality control is good enough that both bells are within spec to one another.

2: Have a back plate machined for the T56 bell JUST to do an alignment with.

Not terribly excited about either of those options. Anybody have any other ideas?

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 04:04 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.