Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Suspension - Brakes - Steering> Brake fluid paint powder coat
User Name
Password
lost password?   |   register now

Thread: Brake fluid paint powder coat Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
12-10-2012 06:34 AM
Trophyman I had master P/C and it held up fine. That's not to say glycol based fluid won't harm P/C. Polyalkylene glycol ether based fluids are very effective at removing paint, as well as P/C, if give sufficient time. I spilled fluid on P/C items, master, callipers etc, many times, but cleaned it imeadeatly. Just be diligent with clean up and you should be fine. DOT 5 sillcone will not harm but problems of it's own.
12-09-2012 04:51 PM
chief36chevy
Brake fluid paint powder coat

Ok I have been reading a ton of articles on the pros and cons of paint vs powder coat and which will hold up when brake fluid is spilled on it.
Iím tearing my truck down to the frame this winter and want to get and all the brackets painted or powder coated.
I used DOT 4 brake fluid in my system, but since I have it tore down it wonít be that much more work to pull the master cyl. and calibrators to flush them completely.
My thoughts were to have everything powder coated then I read that brake fluid can harm the powder coat. If I go this route what would be the best brake fluid to use?
I would just like to get some good advice before I spend a lot on a powder coat job.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 07:33 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.