Hot Rod Forum banner

Mechanical Oil Temperature Gauge question

808 views 3 replies 3 participants last post by  keitho64 
#1 ·
I have an old Stewart Warner mechanical oil temperature gauge. The lead for the sending unit is a hard wire /cable but is too short since this is going in a Corvair and the gauge is designed for a front engine.

Do any of you know if there is a way to splice in an ‘extension’ so I could run the gauge all the way to the dash? The connector / cable looks the same as a mechanical water temperature gauge.

Thanks
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top