Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic -- Hot Rod Forum

Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Transmission - Rearend> 700r4 Help SBC rebuild
User Name
lost password?   |   register now

Thread: 700r4 Help SBC rebuild Reply to Thread
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:
Please select your insurance company (Optional)


Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.

Additional Options
Miscellaneous Options

Topic Review (Newest First)
01-21-2013 10:04 AM
ricoramos Thanks you where right the torque converter wasnt seated properly
01-18-2013 03:17 AM
SSedan64 It sounds like the TC/TorqueConverter isn't fully installed into the Trans. Most likely the TC Hub lugs/splines aren't in the Pump Gear Lugs.
You need to spin & push in on the TC when installing it. The Input Shaft, Stator Support & Pump splines need to engage. Normally hear/feel 3-clicks/clunks.
Do Not use the Bellhousing Bolts to pull the Trans up to Engine, this will break the Pump gear/rotor.

TC Install Info:
Torque Converter Installation Instructions
Automatic Transmission & Torque Converter FAQ - TCIŽ Auto
Automatic Transmission & Torque Converter FAQ - TCIŽ Auto

Make sure your Flexplate bolt pattern will align with the TC bolt pattern. Some have dual bolt patterns but, some don't & wont fit.
01-17-2013 01:16 PM
700r4 Help SBC rebuild

I had a SBC350 TBI engine with a one piece rear main seal and a 700r4 trans. I got rid of the old engine and now have a freshly rebuilt carburated 350 with a 2 piece rear main seal, that I think came off a 1970's vehicle but im not sure what kind.

I finished putting the engine togother and was ready to attach the trany so I can finaly drop it my my 66 c10 ... but then I hit a wall

I placed the original 700r4 torque converted on the tranny and im pretty sure I sat it all the way in, when I try and connect the bell housing to new engine the torque converted presses againts the flywheel and wont turn. Is there a different torque converter? Or what am I doing wrong. The flywheel in using is the one that came with the 2 piece rearmain seal engine,

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

All times are GMT -6. The time now is 05:20 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2017 DragonByte Technologies Ltd.
Copyright 1999 - 2012. All Rights Reserved.