|02-21-2013 05:19 PM|
I did some searching here on the Hot Rodders site a while back looking for header gasket recommendations and found this thread: http://www.hotrodders.com/forum/how-...bc-226930.html
That lead my to use stock manifold gaskets on my headers. If you are running stock heads, with stock port configurations, they work just fine right out of the box.
Not sure though how they will work with the fuels you are using.
Here's the gasket set P/N's I ended up using:
|02-21-2013 05:14 PM|
|02-21-2013 01:43 PM|
I have no trouble with those perforated metal composite type that they supply in the gasket kits. I put high temp silicone (smear) both sides, nip em up most of the way, let it set and fully tighten. Check when cold 3 or 4 times and then occasionally. Keep em tight.
But the MOST IMPORTANT thing, make sure the flange on the header is STRAIGHT!!! Mine had a .100" bow in the middle, no way I could get em to seal. So I filled it up with weld, the ground it, belt sanded it, check with straight edge until it was straight. .....No leaks now!
I feel that so long as your surfaces are straight, pretty much any type gasket would do the job. Keep a check on the bolts....
|02-21-2013 01:30 PM|
What is the best heater Gaskets For Finder wlll headers with Plates, it burning thru in the center flange. I am running methnane or alcohal as fule.