Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Suspension - Brakes - Steering> need help setting up rear suspension
User Name
Password
lost password?   |   register now

Thread: need help setting up rear suspension Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
04-07-2013 09:09 AM
Pupsvette76 It's hard to say what the clearances are with the suspension fully compressed but the floor is gone and replaced up to the back of the front seats no back seat
03-24-2013 10:07 AM
sedanbob You mentioned the driveshaft clearance just behind the transmission (where it won't be moving up and down much). If the rear suspension was fully compressed, and onto the bumpstops, is there still clearance above the driveshaft?
03-23-2013 06:47 PM
Actionjk I've tubbed close to I believe 15 cars in my shop,usually on a Nova,or Camaro,the tunnel is cut out and floor replaced up to about where the rear seat use to begin,if you are trying to keep the back seat,and do a full tub,you"ll have tunnel problems,only other choice is raise the car up higher.
03-22-2013 08:27 PM
Pupsvette76 I'm not sure what to do to get more clearance... the yoke in the Tran is only about 3/8 inch away from th floor an I have to see if it all centers up when the cars on the ground
03-22-2013 08:11 PM
Actionjk Panhard bar should be adjustable and set so when sitting at ride height (or on the ground) rear is centered,driveshaft a little close,I like to see about 3" between tunnel and shaft.
03-22-2013 07:38 PM
Pupsvette76
need help setting up rear suspension

Hey guys I'm trying to set up the suspension on my 72 nova pro street it's a Gm12 bolt with ladder bars and coil overs...just confused about a few things first is that with the drive shaft where the rear is set up now the drive shaft doesn't have a lot of up and down room for suspension travel maybe about an inch and a half how much should I have ? so what I did was change the holes on the coil over bracket
Second is that with the suspension fully relaxed the panhard bar pulls the rear end over to the passenger side is that normal? If not how can I fix it is there a better system to center the rear axle? Thanks in advance gys

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 01:35 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.