Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Suspension - Brakes - Steering> 66 impala front wheel bearing
User Name
Password
lost password?   |   register now

Thread: 66 impala front wheel bearing Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
04-21-2013 07:53 PM
69 widetrack X2 on what everyone has posted...including hand packing the bearings...a tip for getting the proper tension on the bearings is to spin the rotor or drum while your tightening the bearings...this helps to center them and gives you a good indication as to when they have enough pre-load.

Ray
04-21-2013 07:18 PM
NEW INTERIORS I also like to hand pack my bearing the old way..
04-21-2013 07:08 PM
poncho62 I do it the same.....
04-21-2013 04:06 PM
NEW INTERIORS I snug them down to make sure to suck them up,,, Then back off until it just turns freely and then put the cotter pin in.. You don't want them too thight or too loose... Thight enough that it turns freely.. Hope I explained this where you can understand what I'm getting at..

When it's done you should be able to spend the rotor.. If it's too thight,, You can burn them up.... I seen some guy's thighten them so much you can't turn them.. And tell you they have to be that thight...

Make sure you put the cotter pin back in place...

Some people may do it different,, This is the way I do it..
04-21-2013 03:05 PM
grandslam1991
66 impala front wheel bearing

Hey all I need to replace my front wheel bearings on my 66 impala, so my question is how do I set the preload/rotating torque on these bearings? Thanks.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 12:55 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.