|07-04-2013 05:47 PM|
Not much room for a mistake doing it this way..
|07-04-2013 05:43 PM|
|07-04-2013 07:58 AM|
I too really like the $0.99 can spouts too. See, John thinks they're a lot of work but you have to remember he's just a cranky old guy who's become a slacker in his 'experienced age.'
John knows I'm just busting his chops, he's an extraordinarily nice guy and has helped me out a lot in the past.
Back to the topic at hand, when I'm finished with my spout I wipe the majority of the paint off with a dry paper towel, and then just wipe it down with a rag saturated with lacquer thinner and this cleans it right up. The trick getting the bulk of the paint with the dry paper towel first
|07-04-2013 01:06 AM|
|07-04-2013 12:46 AM|
is it hard to stir the paiy thru the holes .LOL LOL
|07-03-2013 09:11 PM|
Still like the tape that I can just throw away.
|07-03-2013 08:50 PM|
|NEW INTERIORS||I just pop two holes in the lid... When done put a piece of tape over the holes...No mess..|
|07-03-2013 08:17 PM|
|evolvo||I have a couple of one's similar to the ones I posted. I got mine from my local paint jobber (Wesco). His don't have a crank handle like the Amazon ones do, his have a small cross bar that hook to his mixing machine. These are what he uses to mix his batches of paint. I use a cordless drill with a T fitting to stir the paint. They are sealed from outside air when closed, they don't drip at all, they stir the paint from the very bottom of the can so the mix stays consistent. They are easy to clean if you get a clean empty can and put in some thinner, stir, shake remove and dry. Do it again if it needs it, ez,pz! There's nothing better IMHO!!!|
|07-03-2013 07:52 PM|
I was at local hardware store and saw these, they work great. Available for gallons or quarts
Shop Encore Plastics Paint Stretcher Spout at Lowes.com
|07-03-2013 06:52 PM|
|496CHEVY3100||I also use the tape to pour to paint into strainer .the hole is to let the paint in the lip drain back into can to stop splatter when replacing lid.|
|07-03-2013 06:44 PM|
|cyclopsblown34||I use the method JC Clark posted. I used to punch the hole in the groove til I learned his trick. It is much cleaner as the paint pours off the crisp edge of the tape and not down the edge of the can.|
|07-03-2013 01:53 PM|
|496CHEVY3100||did you use the plastic I use two holes in all of mine with no leaks.might br a difference in can ,??|
|07-03-2013 01:35 PM|
groove filled up with paint.
|07-03-2013 12:47 PM|
Drill or punch a 1/8 hole in the lip grove of can ,the paint will drain back in to can does not effect seal , no splatter when replacing lid ,I also put a sheet of plastic film under lid before sealing ,makes it much easier to remove lid for next usem
|07-03-2013 12:14 PM|
I learned this trick right here on the forum. Can't believe I had never thought of it but it works really well. All of the gadgets I have come up with are more trouble than they are worth to clean.
|This thread has more than 15 replies. Click here to review the whole thread.|