Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Transmission - Rearend> Manualy operated kickdown pedal idea.
User Name
Password
lost password?   |   register now

Thread: Manualy operated kickdown pedal idea. Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
01-30-2004 07:43 PM
slowturbo The biggest problem with this idea is that the kickdown (aka throttle valve ) linkage does not just trigger kick down. It's position is also one of the things that regulates part throttle upshift points and fluid pressures. A tranny without a properly connected and adjusted KD linkage will burn itself up in short order.
01-29-2004 11:01 PM
Pony Almost anything can be done, the question is: Is it worth it. I your case it's not really worth the trouble. You'd be far better of adding a piece to the linkage and forget about it.
01-29-2004 06:13 PM
powerwagon
Manualy operated kickdown pedal idea.

So I just got through installing a Weland manifold and two barrel holley on my dodge W150 with a 318 motor and NP203 tranny. Now, due to the fact that the Action Plus manifold places the carb a few inches higher, the stock kickdown linkage is to short to reach the side of the carb. I was thinking of all the ways to elongate it to fit when I came up with this idea:

Connect some kind of pull cable (throttle cable, mountain bike brake cable, twine, etc) to the lever on the tranny, and the other end to a small pedal about where a clutch would be.

This would theoretically give me infinite control over when it downshifts, right? Is there some key piece of information about kickdowns that I am missing here, or would this work flawlessly?

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 06:35 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.