Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Engine> Which is better, a Edelbrock or Holly
User Name
Password
lost password?   |   register now

Thread: Which is better, a Edelbrock or Holly Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
11-14-2002 12:59 PM
BstMech Right on will's!
11-14-2002 08:17 AM
Will's41 I too had both. If the motor is mostly stock both out of the box will perform nearly the same. However I feel the Holly is easier to adjust when fine tuning, just my 2 cents....
11-14-2002 07:44 AM
figure8 I have a 350HO crate motor with an Edelbrock 600 elect. choke. I also have a 406 with a 750 Holley, also elec. choke. Both are real cold blooded, The Holley far worse, but both run fine when warmed up. I dont have any exhaust heat to the carb on either motor. I think the Edelbrock is a bit less tempormental, but the holley probably is better for performance. I am going to try a quadrajet next time. Phil
11-14-2002 07:35 AM
Camaro76
Which is better, a Edelbrock or Holly

Im sure this topic can be run for hours on end at the bar room table, ive already had a Edelbrock on my engine once, i chose the Edelbrock becouse of clearnce for the manifold vac port on the manifod for a SBC, i had bad experinces with it

for my new Engine i know i need a 600/650 for it
and i was planing on buying a 600 Holly vac secondaries elec choke, after talking to a few peaple around town im starting to second guess the idea of buying it, i was just wondering some opnions, this will be an everyday driver engine

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 06:54 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.