Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Hotrodding Basics> 7/16" Rocker Studs.
User Name
Password
lost password?   |   register now

Thread: 7/16" Rocker Studs. Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
11-21-2004 04:17 PM
Rustydawg Check out the ARP 100-7101 7/16" studs. I'm in the same boat as you with Perf RPM heads and a set of 7/16" roller rockers. I picked up a set of these ARP studs to work with the new rockers. I haven't swapped them all but have tried threading one in hand tight and it's just the ticket.

The new studs are machined flat across the top of the stud to work with locks too - unlike the cheepo 3/8" studs that the Edelbrock heads came with.

My Edelbrock heads are 7/16" threads for the studs. It's only the upper portion of the original stud that is 3/8".
11-18-2004 07:21 PM
BoomerADF
7/16" Rocker Studs.

Ok I have searched and I cant find an answer to this (maybe I am dumb who knows) but the question I have is I got a set of 7/16" rockers for pretty cheap(brand new set of 1.6:1 Hardland Sharps for $85) but the heads I am looking at are a set of Edelbrock 60889 Summit Link. Anyway the question is what will I need to do for rocker studs? Will/Can I have the heads machined to accept the proper studs? I was looking at ARP's studs but they only offer 3/8" top/bottom or 7/16" bottom nothing with a 3/8" bottom and 7/16" top(makes sense due to the point of the 7/16" rocker). If machining the heads is the option any idea on potentially what it may cost?

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 07:11 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.