Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Engine> piston rings
User Name
Password
lost password?   |   register now

Thread: piston rings Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
03-03-2003 08:42 AM
engineguy Troy,
Definitely use moly rings and make sure that your machine shop prepares the bores properly for these rings, like 320 grit hone. For hyper pistons, I would recommend ductile iron or steel top rings, instead of grey iron. Perfect Circle, Federal-Mogul, Childs & Albert, JE, etc. have these premium rings available. They will hold up better with the higher heat that is retained in the hyper piston crown. As BobC noted, make sure that you follow the piston manufacturer's gap recommendations to the letter.
02-28-2003 05:30 PM
BOBCRMAN@aol.com yes, use the moly ring, be very careful and file fit the correct end gap on the top ring, hypereutectic pistons require different ring gaps than regular cast pistons.
02-28-2003 04:35 PM
DoubleVision I`d use moly rings and have it honed to match them, as for size, you need a set of 40 over rings, 4.125 + 0.040 = 4.165
02-28-2003 02:50 PM
Troy
piston rings

Hello fellas,i am back again.I am trying to find out what type of ring i should use.This is for my 400sbc,with hypereutectic pistons,any particular ring i should use?I was looking in summit,jegs,paw,and have found rings sized at 4.155,my bore is 4.165,is this the size ring i need or what?Thank you.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 03:32 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.