|02-22-2005 08:18 AM|
|02-21-2005 07:18 PM|
You still need to seat the rings and change the oil and filter after the first 1/2 hour.
Even with a roller setup we still break in the motor on the dyno the same as a flat tappet, for 1/2 hour running motor at 2200-2500 RPM with light load monitoring water temps and oil pressure. Drain oil, cut and inspect filter.
|02-21-2005 06:40 PM|
So i can assume no break in is required on the engine then...
For sure i will run some miles on it before cranking it
|02-21-2005 05:21 PM|
|lluciano77||As long as the lifters aren't worn out, you can reuse old roller lifters on a new cam too.|
|02-21-2005 05:20 PM|
No wonder all the new cars use them lol. Ahh the wonders of of modern tech.
|02-21-2005 05:19 PM|
|357f-150||No need to break in the roller camshaft but being a new engine, some people like to take certain steps to ensure the rings seat properly, depends on what your using, your call on that one. Good luck|
|02-21-2005 04:50 PM|
|lluciano77||You don't need any break in with a roller cam. Just make sure everything is safe and drive it.|
|02-21-2005 04:49 PM|
|BOBCRMAN@aol.com||As long as everything is well lubed on startup. There is no actual break in on a roller cam.|
|02-21-2005 04:48 PM|
|SkyMan9600||I think you need to run it "nicely" for a little while before romping on it with a new roller cam, but I don't know... I would like to know the answer to this also guys...|
|02-21-2005 04:42 PM|
new engine, roller cam break in ??
Does i need any breakin for an engine whit a roller lifter/cam ?
I have my brand new 410sbc supercharged ready, already started it
couple of sec. but not sure if the cam need any breakin procedure like
standard cam ?