Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Hotrodding Basics> Engine and transmission mounts
User Name
Password
lost password?   |   register now

Thread: Engine and transmission mounts Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
08-07-2005 08:15 PM
poncho62 Can't see that the tranny was just sitting in a cradle. Upon hard driving the rear of the tranny would jump right out of there and hit the floor.

Also, having the mounts that far apart puts a lot of strain on the bell housing bolts....not recommended. Side mounts started in the cars in 1958.
08-07-2005 07:40 PM
cucumber1949
Engine and transmission mounts

Looking for insight from the experts on the forum.

At a cruise-in last night, I saw a 32 Ford street rod with a small block Chev motor and TH350 trans. I noticed that the engine was mounted using a front mount saddle, and after looking under the car, that the transmission was supported at the aft end of the tail shaft. The tail shaft was resting in a 'V' shaped cradle and was not directly bolted to the transmission - just resting in the cradle. This was an outstanding coupe all around.

I've heard that the early small block Chevys used front mounts but don't now when the side mounts came along.

I'm wondering what the pros and cons are for the front mount, and also if the transmission support I saw has an advantage over the traditional rubber block mount between to the crossmember and transmission.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 11:19 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.