|11-28-2001 05:03 AM|
Thank you for the info, that was my problem I didn't have the tag on the rear end, I will try the idea of turning the wheels. I will try to find the parts you are inquiring about, I have a friend that has a lot of old ford parts.
Thanks again "Railrodder'"
[ November 28, 2001: Message edited by: railrodder ]
|11-28-2001 03:58 AM|
If you have neither of the above, raise the rear axle off the ground and turn the wheel(s) by hand. Notice the number of revolutions of the rear flange (u-joint) as compared to one full turn of the wheel. This will give you a close idea of the ratio (i.e. if the rear flange turns three times as the wheel turns one full revolution, you have a 3.00 to 1 ratio).
Also while turning the wheel, if both wheels turn in the same direction, you have a locking rear. If the wheels turn opposite directions, then you have a open rear.
|11-27-2001 09:42 AM|
How do you determine the gear ratio of a rear end if you are not able to take the rear-end apart.