Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Body - Exterior> Help a noob, welding
User Name
Password
lost password?   |   register now

Thread: Help a noob, welding Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
10-06-2005 06:16 PM
firebird_red A copper backing plate and a mig welder might give you less warp to fix.
10-06-2005 03:26 PM
a69446b I'm in Denver west side
10-06-2005 11:43 AM
35WINDOW What I do is use a Roper Whitney punch and make some small plugs-then I carefully drill the hole to the right size and weld the plugs in-if you are careful with your Welding, you can put less heat into the Door panel (less warping), then Hammer and Dolly the area back to normal (stretching)-by the way, where in Colorado are you?

Craig
10-06-2005 11:33 AM
furrystump If the holes aren't very big you can just place a copper strip over the back of the hole and fill with your welder. Short bursts. The copper supports the bead and acts as a heat sink.
10-06-2005 07:47 AM
a69446b
Help a noob, welding

OK
I've got no experiance welding ( but I did sleep at a Holliday Inn last night ) I've done the rest of my car and I want to tackle this.
The project is to eliminate the holes for the chrome trim on a door. I have a small O/A welder that I have a basic understanding of, I have a spare door I can practice on. What's the best way to do this, fill in the holes with weld material, cut out a small piece and weld it in.
How do I keep from warping the door
Thanks Bert

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 10:27 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.