|12-14-2005 06:15 PM|
|61bone||Anything you put over these will affect their holding power and affect their accuracyplus burned plastic stinks. Use a rag to wipe the crud to one end and pick it off with your fingers. I have a piece of flat strap over my bench I store them on. B low the spatter off the iron before you put them on and again before you remove them and place on the strap, not the bench|
|12-14-2005 03:16 PM|
I have one of them round magnets on a stick for picking up stuff
(the official fat guys tool)
any how i took a piece of aluminum and made a shield that slides over it with a steel pop rivet to hold it on while its empty
other than that KEEP YOUR MAGNETS AWAY FROM METAL FILINGS
|12-14-2005 01:57 PM|
|oldred||Not dumb at all, I have even wrapped them in thin rags before using them so that the junk will be removed when you take the rags off.|
|12-14-2005 01:54 PM|
Actually a fellow might wish to put his magnets in a sandwich baggy..that way he can just peel of the baggy and have a clean magnet..heavens it just may work..!!!
|12-14-2005 01:19 PM|
What about wrapping them with wax paper and using that shipping tape with threads in it to hold the paper on?
I know it wont help with welding splatter but I would think it would work well for shavings and metal grinding dust...
I usually use a rag too...
|12-14-2005 11:12 AM|
|oldred||Sha, That's an age old question. I usually just use a rag to wipe around them in one direction to bunch up the junk in one spot to make it easier to remove. "There just ain't no easy way"- Seriously a magnet is just that a magnet and there is no way to make it let go of what it is holding unless it is an electro magnet that can be turned off.|
|12-14-2005 10:32 AM|
|astroracer||I wipe them with a rag....|
|12-13-2005 10:48 PM|
|Speedyoldtruckdotcom||Use a much stronger magnet (Cobalt or ceramic, you can pick them up at surplus shops) wrapped in a thick canvas rag (anything that isn't very thick will just rip)|
|12-13-2005 10:08 PM|
I wipe mine off with a rag and sometimes I use a scraper..
|12-13-2005 09:13 PM|
Alright, I bought a lot of 25 of those red arrow shaped welding magnets, they are great and I only paid like $20. but being in a fab shop metal shavings and pieces get stuck to them, how can i keep them clean and get the metal off of them? I tried air and that didn't work.