Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Transmission - Rearend> 9" Ford Breather
User Name
Password
lost password?   |   register now

Thread: 9" Ford Breather Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
02-05-2003 05:14 AM
tm454 Contact Dutchman on line and see if they offer a resolve to your problem. If you get into the rearend you may find no axle seals in the axle housing. There should be a seal just inside the housing past the Diff. One on the left and one on the right. This keeps gear oil from running the length of the tubes and out of the bearing. No big deal, drop the drive sheft, remove the axle bolts behind the break plate and slide the axle out. Remove the Diff. bolts and remove the diff. and place the seals in the axle tubes, one on the left and one omn the right of the diff.


Todd
02-05-2003 04:19 AM
38ChevyCoupe I would drill a small hole in the axle tube and tap it to 1/8 pipe threads
02-05-2003 02:46 AM
motionsigns
9" Ford Breather

Just bought a car with a 9" Ford Rearend (Dutchman?) Strange gear carrier, etc. Getting quite a bit of gear oil past the axle seals and suspect it might be due no breather on the rear end... looked all up and down the axle shafts and can't find one. There's a pipe plug on the carrier itself. What do you think of using it and plumbing a line away from the carrier to create a vent. Is there an easier way?

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 09:28 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.