Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Transmission - Rearend> Retro fit a ZF 6-speed in a 56 Chevy with a bench seat
User Name
Password
lost password?   |   register now

Thread: Retro fit a ZF 6-speed in a 56 Chevy with a bench seat Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
03-13-2003 04:57 PM
bo ty 55 I'm not familiar with the trans but i've got a super t-10 in a 55 with a bench. I went with a hurst compition plus linkage with the "C" shifter to get around the bench. Hope you alredy have the clutch arm in. Then you'll need to match the front splines on the tranny to a clutch disc, then check the legnth of the tranny to see if you need to rework the drive shaft. One other thing, match the front yoke of the drive shaft to the rear splines on the trans. Thats about all I know.
03-13-2003 03:32 PM
balweav
Retro fit a ZF 6-speed in a 56 Chevy with a bench seat

Hi everyone I'm new at this so you might notice.

I would like to install a ZF 6-speed in a 56 Chevy and keep the original Bench seat. My problem might be where the shifter is located. I haven't tryed yet but looking for the pitfalls before I start.

I was told that I would have a better chance putting the ZF in than a Borg Warner since the Borg Warner is a toploader and looks like it would come up under the seat the ZF isn't so maybe could be adapted.
Thanks for any help

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 11:57 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.