Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Engine> chevy 350 timing
User Name
Password
lost password?   |   register now

Thread: chevy 350 timing Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
02-08-2006 07:56 PM
Rhansen 10 deg. initial and 18 mech. will only give 28 at WOT. I'm sure your motor could handle 36 (or more) at WOT. This would mean setting initial at 18 (unless your mechanical adv. is adjustable) and having up to 46 while cruising. I used to run 16 initial with 20 mech and 10 vac on a mild SBC (~285 hp) no problems. I ran the vac adv on full manifold instead of ported so it would see 26 deg. at idle. It saw better mpg and eliminated a "flat spot" in the throttle transition switching from the ported source to full manifold vac.
02-07-2006 10:01 AM
johnsongrass1 All in by 2800
02-07-2006 08:53 AM
stanjr41
chevy 350 timing

I finally got rid of all the gremlins and am ready to set things right.The drivetrain consists of a rear end/with approx. 3.90 gears;a 350 turbo trans.The engine consists of a 260 h.p. g.m. goodwrench longblock,w/a performer manifold;a 600 holley carb/with jets changed from #64 to#62;autolite 52 plugs,accel super stock suppression 8mm wires, and an accel electronic distributor set at 10 degrees initial,10 degrees in an adjustable vac,and 18 degrees mechanical for a total of 38 degrees,and an accel coil specifically for the dist.Any suggestions for a timing curve would be appreciated.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 06:38 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.