Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Engine> 366 Big Block Chevy
User Name
Password
lost password?   |   register now

Thread: 366 Big Block Chevy Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
04-09-2006 08:28 PM
techinspector1 Sorry to bust your bubble young man, but the 366 is pretty much worthless as a performance motor. It is a big block motor, but is the smallest of the big blocks. The tiny bore (3.935") cannot be bored far enough to yield any appreciable cubic inches. The stock stroke is 3.760", same as the 396 and 427, but both those motors use a larger bore. You could install a stroker crank for more cubic inches, but the cost of the crank and special pistons would be prohibitive compared to the power you could get from other motor combinations.

To answer your question about the deck, that's the flat part of the block where the heads bolt on. The tall deck block is (I believe) 0.400" taller than a standard block like a 396, 427 and 454.

There were some tall deck 427 and 454 blocks that can be used effectively to make a large displacement motor, but your 366 block isn't one of them. Sorry.
04-09-2006 06:32 PM
chevelle4542speed
366 Big Block Chevy 700+ HP

I Have Just Got A 366 Block. Iwanted To No If It Could Be A Performer Engine To Put In My Chevelle. I Read That U Could Bore It Out To A 467 Or 470 C.i. Is That True. Wat Is The Biggest U Can Bore It To.? I Keep Reading About Tall Deck. Wat Is A Deck Were Is It Located? Which One Is Better Short Or Tall? I Read On Hotrod Magizine U Can Get Over 700 Horse On A 11.o/1 Compression Ratio From This Motor. Wat Are Your Thought And Knowlede On This Engine? Thanks For Your Help!!
I Am Young And Trying To Learn As Much As Possoble About Automotive.
THE SITE I READ WAS http://WWW.POPULARHOTRODDING.COM/ENG...0402PHR.SAVER/

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 03:24 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.