Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Transmission - Rearend> overdriveconversion 80 chevy p/u
User Name
Password
lost password?   |   register now

Thread: overdriveconversion 80 chevy p/u Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
04-15-2006 01:54 PM
Jmark what trans do you have now? What engine now? Lots of variables.

I'll take a guess at a V8 and a TH350. If so, the TH350 "should" have a 9" tail housing. If it does, the 700R4 is a bolt in swap. Drive shaft stays the same, cooler lines stay the same but may need metric adaptors, not sure.

Crossmember stays the same as does the mount. Shift linkage is the same but you'll need to remember where the indicator ends up since you are adding one more detent.

Kickdown cable will need to be changed to a TV cable and you MUST have it set correctly. You may or may not need a new TV cable bracket at the rear of the carb. You may or may not need to correct the carb linkage geometry, depends on what carb you are running.

Lockup can be done many ways, from a simple switch on the dash, to a vacuum operated model that kicks OD in at a set vac reading and in 4th gear only, if you buy that specific one. Again, lots of choices, all of which work.

Mark
04-15-2006 12:09 PM
richard stewart 3rd
richard stewart 3rd

wrong thread sorry
04-15-2006 11:08 AM
silverado c10
overdriveconversion 80 chevy p/u

need info on insallation pertaining to driveshaft length .tvs cable. trans coolerlines shifter linkage fluid level dipstick & tube and lockup control

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 08:09 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.