Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Transmission - Rearend> installiation 700r4
User Name
Password
lost password?   |   register now

Thread: installiation 700r4 Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
04-18-2006 02:29 AM
curtis73 If you would rather do it without many mods, try a 200-4r. They are a direct bolt in; length, driveshaft, the works. You'll still have to move the crossmember, but that's about it. It will require a TV cable, but no vacuum. A healthy 200-4r will pretty easily last behind anything that 1970 put out with the exception of maybe the LS5 and LS6 torque levels.
04-18-2006 12:23 AM
Siggy_Freud No electronics should be required. You wont have converter lockup however. You'll have to get a TV cable setup and install or properly making sure to set the line pressure correctly. If you search here or on google you'll find plenty of instructions. Search for TV cable and 700r4 and you'll get pictures of what you need. You'll also need to configure your shifter or get another shifter to be able to select the full range of gears (as it has one more gear than the th-350).

Guides say to shorten the drive shaft 3 inches. Mine measured to be 3.5. I split the difference when I did the conversion. Since its a slip yoke you have a little room for error.
04-17-2006 05:27 PM
1971 Chevelle There are wires for the torque converter lockup. The wires go to the gas pedal, brake, and cruise if you have it. There might be one more wire. You may have to dent your floorboard to get the transmission to fit. Are you sure your 700r4 is strong enough to hold up? Because a stock th-350 is stronger than a stock 700r4.
04-17-2006 04:39 PM
chevelle4542speed
installiation 700r4

i have a 70 chevelle that had a th 350 intill i broke the case inhalf around the tork conv. but i have 700r4 what do i need to install this i know i will have to move the cross mem and shortin the drive shaft. but what about electronics does it have any? does it shift elec or by oil pressure . please help.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 09:23 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.