Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic -- Hot Rod Forum

Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Engine> 87 Chevy 350 TBI rod & main Clearance question
User Name
lost password?   |   register now

Thread: 87 Chevy 350 TBI rod & main Clearance question Reply to Thread
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:
Please select your insurance company (Optional)


Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.

Additional Options
Miscellaneous Options

Topic Review (Newest First)
05-20-2006 04:18 PM
Mustangsaly any one know stock HP & TQ #s of a stock 87 Chevy 350 TBI engine ?


05-19-2006 11:28 AM
Mustangsaly bout how ponies is this putting out stock ?

05-19-2006 11:13 AM
DoubleVision If the rings are replacement rings for the stockers than there really is no worry unless there is excessive bore wear. As for the bearing clearences remember this rule of thumb: Anything under .001 is not enough and anything over .003 is too much.
05-19-2006 11:05 AM
87 Chevy 350 TBI rod & main Clearance question

what is acceptable rod & main Clearances on a stock 87 Chevy 350 TBI engine ? (this motor was pulled 4 low oil pressure) this will be a all stock budget rebuild on a 87 Chevy 350 with fresh heads. what should ring gaps be ? or is there suggested ring gap from the ring manufactures on stock pistons (hoping I can hot tank this block & just hone the block,time will tell) ? where is good place to purchase a rebuild kit 4 this (mght need cam & lifters to) ? any other other input welcome.


Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

All times are GMT -6. The time now is 04:39 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2017 DragonByte Technologies Ltd.
Copyright 1999 - 2012. All Rights Reserved.