Hot Rod Forum banner

Chassis Engineering front 4 bar suspension 1940 ford

3K views 1 reply 2 participants last post by  woodz428 
#1 ·
Anyone familiar with the pros-cons of this setup? I put it in my 1940 ford years ago and I am about to get it on the road and Chassis ENgineering wants nothing to do with suttorting this setup because they no longer make it. Anyone else running this setup, or heard anything good or bad about it?

photos

[ October 16, 2002: Message edited by: hvyh20 ]

[ October 16, 2002: Message edited by: hvyh20 ]</p>
 
#2 ·
I didn't realize they stopped offering the 4 bar. There are many companies that still offer them and are run on lots of rods, so I don't think you should have any problems. Chassis engineering has a good rep so the components are probably of good quality. I'm going to look into this since 4 bars and M2 front ends are about all anyone runs anymore.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top