Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Transmission - Rearend> Grease Slung on Floor Pan Above Pinion U-Joint
User Name
Password
lost password?   |   register now

Thread: Grease Slung on Floor Pan Above Pinion U-Joint Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
10-28-2006 05:13 AM
garyroushkolb
grease slinging on floorpan

It sure sounds like a U-joint problem about to happen, the vibration could have been caused by the joint and when it heated up the grease exited where it was supposed to be. I'd pull the drive shaft and take apart the joint and look then you'll know. Hopefully it was just an excess of grease, but better to know for sure. You'll be able to see the wear easily on the cross.
10-28-2006 04:48 AM
JohnTN
Grease Slung on Floor Pan Above Pinion U-Joint

After driving streetrod 2400 miles with a slight drivetrain vibration I finally checked the driveline angles and found the rearend pinion to be 6.5* up. I was able to adjust this to 2.5* up and the vibration is gone, but while under the car I noticed a swash of grease across the floor pan right above the rearend U-joint/pinion connection like grease has been slinging off of something.

The driveshaft and u-joint are new except for the 2400 miles the car has been driven.

Would vibration have caused grease to sling out or is this an indicator the u-joint might be bad? I haven't noticed any clunking or unusual sounds from the rear.

Should I just pump some more grease into the u-joint grease fitting?

John

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 02:17 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.