Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Engine> How hot do the A.I.R. tubes get?
User Name
Password
lost password?   |   register now

Thread: How hot do the A.I.R. tubes get? Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
01-22-2007 04:54 PM
Ozz1967 It's for my 1984 Trans Am. I put headers on it and then arced one of my plug wires to the headers. So I bought a new rotor, cap and plug wires along with this sweet wire loom from Summit...only because my Headers are emission legal, and have the A.I.R. tubes, it don't fit. I routed the wires and no matter how I route them, there is some point where they are touching the tubes. This is especially prevelant on the drivers side, numbers 1 and 3 cylinders. It's not a show car by any means, I just want it to work right and not arc another plug wire two months down the road from insulation breakdown.
01-22-2007 04:23 PM
327NUT Without seeing it then its hard to make suggestions, and if you don't want to spend anymore money on it then I would just wrap some thermal insulation, like header wrap around the tubes in the proper location and wire tie the plug wires to the insulation. I know that sounds kinda hank but sometimes you just gotta do.....and I'm assuming its not a show car.....
01-22-2007 02:57 PM
Ozz1967 I bought two separate wire looms, but because of the A.I.R. tubes, they don't fit. There is loom from Summit that I'm looking at, but it's yet another $40.00 with shipping to get them. I was just hoping I could leave the plug wires where they are without hurting anything.
01-22-2007 01:59 PM
327NUT They should'nt get that hot but I still would'nt let them touch the tubes. Can't you use some wire loom holders/seperators to reroute them?
01-22-2007 10:55 AM
Ozz1967
How hot do the A.I.R. tubes get?

I recently put in a new set of plug wires but no matter how I route them they end up resting on the A.I.R. tubes coming from my headers. Does anyone know if they get hot enough to melt the plug wires?

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 09:27 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.