I need a driveshaft for a '72 Duster but found one for a '72 Dart that is approx. 3 or 4 inches to long. I am going to have it shortened but need to know how to measure. If I slide the driveshaft into the tranny, how far should I pull it out before measuring? Or, does anyone know the exact length of a '72 Duster driveshaft?
At ride height.... install front yoke all the way in....pull out 1"...measure frome center to center on u-joints... Just make sure measurements are at ride height.
I would ask the person who is going to shorten the drive shaft, he might want the mesurment from the trans output shaft to the rear yoke.
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
Hot Rod Forum
2.2M posts
175.6K members
Since 2001
A forum community dedicated to hot rod owners and enthusiasts. Come join the discussion about restoration, builds, performance, modifications, classifieds, troubleshooting, maintenance, and more!