Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Engine> need help with numbers
User Name
Password
lost password?   |   register now

Thread: need help with numbers Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
05-04-2007 11:52 AM
fiftyfivegasser
need help with numbers

I recently purchased a 350 engine origionally run in a 72 Z28. The casting numbers identify the engine as an LT1 350/255hp (CKT/3970010).
I purchased the engine from a guy who had installed it in a 65 GTO/4-speed. I heard the engine run and it had a somewhat strong lope at idle and run strong. He removed the engine to go back stock 389 tri-power. I plan to install the 350 in my 55 gasser project car after a few more modifications.

My question regards the heads, intake and bellhousing.

1. According to my research, the factory intake should be numbered as 3959594 with a Holley carb. What it has looks like an aluminum finned intake with cast numbers 14057053/GM CFM and the carb is a Rochester 4-bbl. It doesn't appear to be hi-rise. Any ideas what I have?

2. Regarding the heads, where do I find the casting numbers? I find none on the outside casing. It has straight plugs (not slanted).

3. Last is the bellhousing..the casting number is 3815891/B225/GM6. I'm not sure this is the origional housing since I cannot find this number anywhere doing a search. With all the engine swaps, not sure what I have. Did get a flywheel, starter and clutch fork. Clutch wear on flywheel measures 11". Any ideas on this one?

Before I start adding to the engine and drivetrain, I would like to know that the parts fit what I think I have. Need clutch/pressure plate, SD Trans and carb.(among other things). Would like to know also that the heads are not stock since I've heard the compression is poor on the stock heads for this model. Haven't remove the valve covers yet to determine tappets installed.

Thanks for any help or ideas.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 11:38 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.