Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Body - Exterior> Whats the best way to de texture plastics?
User Name
Password
lost password?   |   register now

Thread: Whats the best way to de texture plastics? Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
07-23-2007 05:37 AM
mrcleanr6 i usually have to do this alot for the sportbike guys. you can sand it off and that is really probably the best way but it is alot of work getting it off and resurfacing. i usually spray them with adhesion promoter then 2k. dont bother with the flex additive. its a marketing gimmick that doesn't really work. if you have a good high build primer then 3-4 coats should take care of most textured plastics. you could swap out the 2k for an epoxy but you'll need more coats....usually. epoxy stays flexible forever and you usually dont have as many shrinkage issues with it. your call, either way will work
07-22-2007 10:40 AM
Steve UK Bob the last plastic I sanded was rough. It was like trying to prime a furry blanket ha ha

When you say sand it down, what grit are you thinking?
07-22-2007 07:53 AM
baddbob Sand the texture off then go over it well with a red/maroon scotchbrite wet and that usually knocks most of the fuzzies off, prime, sand and reprime if necessary.
07-22-2007 04:32 AM
flyinbrick hi there.

I suggest using a fairly fine wet and dry paper and tons of water- im pretty sure that wont fuzz.
07-22-2007 02:46 AM
Steve UK
Whats the best way to de texture plastics?

Hi guys

I have been doing quite a few plastic parts lately. The customers want the grain smoothed from the plastic & a nice smooth paint job over them.

I have tried a few ways. Firstly sand the grain from the plastic. That was a big mistake because the plastic furs up & it is then a nightmare to prime & make it smooth again.

The second way is the clean the plastic, plastic prime it then followed by 2k primer with flexible addative @ 30% in it. Thats much better but I find I have to re prime 3 times before it is really sweet.

Does flexible additive make the primer less high build? Whats your thoughts guys?

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 12:20 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.