Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic -- Hot Rod Forum

Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Engine> Need Correct Coolant Hose Routing
User Name
lost password?   |   register now

Thread: Need Correct Coolant Hose Routing Reply to Thread
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:
Please select your insurance company (Optional)


Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.

Additional Options
Miscellaneous Options

Topic Review (Newest First)
09-02-2007 05:20 PM
75gmck25 The stock heater hose routing goes from the intake manifold fitting on the front, passenger side of the manifold over the heater core and back to a fitting on the radiator. I don't think an '81 used the fitting on the water pump.

You have the right location for the temp sensor. Most folks will say that the head location reads a little higher than the intake manifold fitting, but mine seems to read about the same in both locations. If you have headers it might be easier to use the intake manifold fitting.

09-02-2007 03:50 PM
Need Correct Coolant Hose Routing

Can someone tell me if this is correct. I have an '81 El Camino that originally came with a 305 and AC. I took the 305 out as well as the AC and put a freshly rebuilt 350 in its place. I have decided to bypass the heater also, atleast for the time being. I have just broke this engine in. It does not have more than 45 minutes run time on it. I have noticed my temp is hovering right around the 195-200 degree mark. My thermostat is new; 180 temp. the radiator is the original radiator which I believe-not sure how to tell-is a two core with a shroud. I have an RPM air gap intake manifold. I put pipe plugs in the threaded holes--one in the front, one in the back of the intake manifold--leading to the coolant passages in the intake manifold. After reading some of the other post, I don't think I should have done this. Since I am not using my heater at the moment, should I take the pipe plug out in the front of the intake manifold, and run a hose from that to the top of the water pump which is a new long style water pump?
Also, I have my temp sensor for my temp gauge screwed into the block between cylinders 1 and 3. Is this the correct place or should I relocate it to the top of the intake manifold?
Once again, thank you for all responses.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

All times are GMT -6. The time now is 05:23 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2017 DragonByte Technologies Ltd.
Copyright 1999 - 2012. All Rights Reserved.