|12-30-2007 06:24 AM|
|speedydeedy||71corvette You Got It.|
|12-29-2007 10:34 PM|
|71corvette||is the battery strong enough? if so check the ground. sounds like it is not getting enough voltage to spin fast enough to engage the bendix|
|12-28-2007 08:13 PM|
New High Torque Starter Connection prob .
Ok Guys ,, Here is my thing on this New Starter ..
I have a 70" BBC .. I swaped the old starter of the engine , & I got me a Mini starter ..
I got it all hooked up & tried to start the car .. BUt The starter would just spin ..
The Shaft would not come out of its shell for some reason ..
It just spins ... ( I was thinking I might have switched the wires wrong )
I gave up ,, & I took the starter to get checked ,,, & It checked good ..
They hooked it up to the tester ,, & shaft came out properly ,,, The way it was supposed to ..
So I took it home & tried switching the wires around again , But It still did the same thing (Nothing but just spin ) Without the shaft coming out ...
Can someone please Help .... ?
The wiring harness & car is a 72 Camaro ... Stock starter had 3 wires connected to it , PLus the Battery cable ...