Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Engine> Oil and Bearings a.k.a. Hydrodynamic Bearings - FWIW
User Name
Password
lost password?   |   register now

Thread: Oil and Bearings a.k.a. Hydrodynamic Bearings - FWIW Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
03-25-2008 08:55 AM
willys36@aol.com Good link. Yes hydrodynamic bearings are quite complex. Big section of Shigley's Machine Design text devoted to it. Guaranteed question on the final of any ME machine design course.

The principle of this bearing was developed on early railroad truck axles (a whole bunch of mechanical engineering technology came from railroads). Designers were using wooden bearings on the truck axles, lubed with animal fat. The lube was filled from the top but kept leaking out the hole on top of the bearing. They tried all kinds of plugs for that hole but the plugs quickly blew out, even threaded ones. Finally did the math and determined that viscous lubricants 'wedged' themselves into the space between the axle and bearing and pressured up to whatever pressure it took to support the two parts on a couple molecules of lube. The hydrodynamic effect actually 'pumps' the lube to very high pressures and prevents metal to metal contact. Lube viscosity vs. temperature, lube temperature tolerance, bearing material pressure and temperature tolerance, surface finish, width and diameter of bearing (needs to be wide and long enough to carry the load, not so wide that friction heat destroys metals and lube), assembly methods, etc. all have to be considered for a successful design.
03-17-2008 09:36 AM
Stroke
Oil and Bearings a.k.a. Hydrodynamic Bearings - FWIW

A good read for anybody interested...

Quote:
Hydrodynamic Bearings

Journal bearing design is complex. It involves optimizing clearances, bearing length, minimum film lubricant, viscosity, flow rate, and inlet slots. Design equations are available, but their solution is time consuming unless done on a computer. Fortunately, these equations have been reduced to chart form, and a wide variety of design problems can be solved with various charts in the literature.

For more info see this link http://www.bearings.machinedesign.co...emech6_18.aspx

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 05:15 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.