Hot Rod Forum banner
Status
Not open for further replies.

what seats fit a model coupe???

13K views 7 replies 8 participants last post by  Gene Neal 
#1 ·
hi, i am streetrodding a 30 ford coupe. does anyone know what seats will fit this car? it is small and narrow inside. i was told the shorter bench seat from the middle of a caravan would fit, but they seem too wide. i like the bench seat better, but will use buckets if i have to. i would appreciate any help. thanks!!!!!! mike
 
#3 ·
i used a seat out of a 73-79 ford pickup in my 30 model a coupe. just remove seat cover and foam, cut metal frame and weld. cut same amount out of foam, glue together. a electric carving knife works perfect for cutting foam. the completed seat can be made in less than an hour , and works perfect. hope this might help.
 
#7 ·
Just got a set of Mazda Miata buckets for my 1931 coupe project. They fit across just fine but I am going to have to raise them up from the floor. Been told Scats fit also and school bus seats work. The middle seat from a carvan work. Measure higher up than floor. You find a little more width. I believe anything 40" or less will work. :D
 
Status
Not open for further replies.
You have insufficient privileges to reply here.
Top