Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic -- Hot Rod Forum

Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Electrical> dtc's on obd2 Need help understanding.
User Name
lost password?   |   register now

Thread: dtc's on obd2 Need help understanding. Reply to Thread
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:
Please select your insurance company (Optional)


Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.

Additional Options
Miscellaneous Options

Topic Review (Newest First)
04-23-2008 03:12 PM
krruzer Update on dtc690, spoke to the programmer about this and he states that the original wiring harness had a relay, however, they just turn this circuit off when they reprogram the computer for there harness. He states this won't cause any problems to the computer.
04-23-2008 01:39 PM
krruzer This aftermarket wiring harness comes with a 8 panel fuse block and has two relays to my knowledge. One for the electrical fuel pump and the other is a starter relay. I also ,wanted to mention this also has a ez wire fuse panel. Thanks for your help.
04-21-2008 09:41 PM
carsavvycook p0690 is set when the ecm detects voltage with the switch is off, this being from the relay feedback circuit(pin 86 if I remember). The brown wire at the relay is the wire the computer commands off. Check it for power with the key off.
04-21-2008 08:41 PM
sharpe427 The lean code would more than likely be a vacuum leak somewhere. The 690 code is sensing the voltage input to the ECM power circuit is too high...make sure that the oe GTO circuit did not reduce input to the ecm (not run 13.8-14.1V straight off the alternator). An understanding garage or friend would be able to get you a spec sheet and wiring diagram.
04-21-2008 04:13 PM
dtc's on obd2 Need help understanding.

I have just finished a 37 ford fiberglass street rod with a 6 liter engine and automatic trans.out of a 06 GTO 6000 miles. The wiring harness is from street and performance. The computer has also been reworked by them. My question is, I have a check engine light on and after scanning the trouble codes one being po174 system to lean. (Possible fuel injector restriction ) The second code po690 has me stumped ecm/pcm power relay, sense circuit Hi. If anyone can shed some light on this I would appreciate the feed back.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

All times are GMT -6. The time now is 11:41 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2017 DragonByte Technologies Ltd.
Copyright 1999 - 2012. All Rights Reserved.