|07-27-2008 12:57 PM|
|07-27-2008 12:14 PM|
you can buy a oem approx 3/8" thick 4 hole insulating carb gasket at your local parts store for about $10?....
the Edelbrock 3/8" insulator 4 hole gasket is about $14?
|07-27-2008 11:47 AM|
|vetteman||Thanks for the feedback. Although the car does run well, I thought it could use a little tweaking off idle. Heat soak was the reason for the 1/2" spacer, and I did do some checking about adding another 1/2" to an already "high" intake, and came to a conclusion a 1/2" wouldn't really affect it that much. So I guess if i'm bored, i'll experiment with the four hole plate I have.|
|07-27-2008 10:08 AM|
are you tuning for better at the strip or better on the street atomization???
here's a good spacers explaination article....
and there is another good article in the Knowledge Base link at the top of the page.....
yes, your present 1/2" open spacer may well be adding a few more WOT peak HP ponies...."but".... at street rpms it is making the RPM dual plane intake behave as a open plenum design because there is no divider wall at the carb bottem...
on a intake stroke the piston is trying to pull a vacuum to make a strong carb Hg (good velocity for excellent atomization) signal from all 8 of the intake runners cubic inches of area due to no divider instead of just 4 runners worth of area....
(and worse it's 1/2 the carb signal at the carb because it is pulling from both primaries)
if your looking for better street driving performance I'd remove the 1/2" open spacer and test drive it....the "high rise" RPM intake already has a plenty tall carb base to plenum bottem distance...
|07-27-2008 09:14 AM|
It looks to be more of a gasket.
Stay with an open spacer, one inch better.
I went to a one inch open after a four hole and the difference was
noticeable immediately with the idle.
More torquey as both banks can call upon the whole carb.
Take a lookat this from CarJunkies may take awhile to load.
|07-27-2008 08:31 AM|
4 hole spacer plates help atomize the fuel/air in otherwise big manifolds.
helps get rid of the bog /hesitation off the line.
but judging from the pic that spacer is too thin.
at least 1" to notice a difference.
|07-27-2008 06:46 AM|
carb spacer plate
I have this plate, and was wondering if it would help atomize the fuel a little better at low to mid rpm's. I have a performer rpm, Holley 650HP, 1/2" open carb spacer. This motor was dyno tuned, but I never thought about trying this plate. This motor is in a 64 vette, 4-sp, 327-350. Any thoughts?