Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic -- Hot Rod Forum

Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Engine> firing on two cylinders
User Name
lost password?   |   register now

Thread: firing on two cylinders Reply to Thread
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:
Please select your insurance company (Optional)


Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.

Additional Options
Miscellaneous Options

Topic Review (Newest First)
08-22-2008 03:57 PM
DoubleVision If you are only getting spark to a few cylinders by checking each with the timing light then you have a problem in the distributor as each wire should make the timing light put out a signal. First off, I don`t know what year vehicle you placed it into, but the HEI must recieve a 12 volt signal, so check the power wire running to it for 12 volts constant. If that checks okay then it could be anything in the distributor from a bad cap to bad wires to a coil, pickup coil or module going south.
08-22-2008 02:51 PM
Jmark Well, it's kinda time to go back to ground zero and start checking things.

You say you changed cams?
1. Are the timing gears set up correctly?
2. Are the valves too tight? Loosing compression?
3. Is the dist. installed with the rotor pointing to #1 wire when the engine is at TDC on #1 cylinder?
4. do a compression test. ALL low would make me re-visit the cam/chain install. Some high and some low would tell me to re-ck the valve adjustment.
5. Did you loose the ground to the HEI? Crappy spark will cause a timing light to not work, or work sometimes.
6. Is the HEI a known good unit?
7. Was the engine a known good unit? LOL

Just things to check. Sometimes it's good to go back to square one and see what got missed.
08-22-2008 01:56 PM
firing on two cylinders

Im so lost. just put a 327 out of my camaro I sold into a Truck, I changed the cam . Ive had it running twice, but now I cannot get it to run and the only header tubes warm like thier firing are 3 and 4. im running an HEI with 8.8 wires I cleaned all the plugs and gapped them At .35 and if i pull #1 it has a spark but for some reason i can run my time gun off 3 but not 1 what the *&%( is going on with this thing im lost.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

All times are GMT -6. The time now is 09:04 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2017 DragonByte Technologies Ltd.
Copyright 1999 - 2012. All Rights Reserved.