|10-07-2008 09:29 PM|
I have one for sale right now on ebay
|09-16-2008 11:29 AM|
|09-15-2008 08:07 PM|
Yeah, the original motor and trans is long gone and the wiring was a hacked up mess so any provisions for a factory kickdown are no longer.
I do remember a switch on the intake that was not hooked up and there were no wires. I thought it was for the switch pitch convertor. The ST300 did use one didn't it?
|09-15-2008 06:54 PM|
|09-15-2008 02:52 PM|
|09-15-2008 01:52 PM|
|richard stewart 3rd||
You have it correct,
12v to one side of switch then to trans.
|09-15-2008 01:14 PM|
Skylark TH-400 kick down switch
I have a '66 Skylark that I put a 455 and TH-400 into. I'd like to hook up the kick down on the trans but 66s didn't come with the 400 so it doesn't have the wiring for the electric kick down.
I've been told I can just mount a micro switch on the gas peddle but I don't know how to wire it. Is it just a 12 volt source to the switch and then a wire from the switch to the kick down solenoid on the trans?
Thanks in advance.