Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Body - Exterior> Camaro Door Striker Reinforcement Panel
User Name
Password
lost password?   |   register now

Thread: Camaro Door Striker Reinforcement Panel Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
10-13-2008 09:58 PM
Rag top bird If you are careful you can do this and not have to paint the outer quarter first you need the part in hand then make sure they are the same then if you look in the door jamb you can see the welds where the cage bolt is welded in take a 3/8 drill bit in a drill and drill the welds do not drill all the way through then take a hammer and a chisel and cut the rest apart from inside the quarter then fit the new one and weld through the old weld holes in the door jamb
10-13-2008 11:40 AM
OneMoreTime Looks like that would be the piece you need..I would get it in hand before doing any cutting as you may be able to see where to cut with minimal repair needed..hope you have good welding skills...

Good luck
Sam
10-13-2008 11:11 AM
hoffmandirt
Camaro Door Striker Reinforcement Panel

I found a rot spot on my 1979 camaro after thoroughly going over it. I took out the vent louvers in the door jams. Then I stuck my arm down in to the inside of the quarter panel and I pressed on the back of the door jam (where the door striker is bolted on, except down near the bottom). This piece is rotted out, but it doesn't come through the front (theres two panels). Is this number 34 on this page http://www.nastyz28.com/tech/e-78smetal.html or is this the quarter panel? To me, it seems like the reinforcement panel goes behind the quarter panel, not in front like the image is showing. What are my options for repairing this? Also is this part available? I can't seem to find it. It's a bummer that I have to cut perfectly good quarter panels to fix this.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 08:12 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.