Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Engine> Where do the mounts go?
User Name
Password
lost password?   |   register now

Thread: Where do the mounts go? Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
11-14-2002 05:46 AM
Maverick Yep! Iam in the process of doing the same thing in my '49 Chevy. Mocking it up while holding the engine with a cherry picker is the best way to get it right. Good luck!

11-13-2002 08:11 PM
chevota I have done engine swaps in a couple trucks (mainly toyota) but what I have done is bolt engine to transmission and bolt tranny to xmember. Attach motor mounts to engine and tack weld them in place. Then the motor mounts are exactly where they need to be.
11-06-2001 08:52 AM
duckhunter
Where do the mounts go?

Hi all,
swaping out a 235 thriftmaster for a 283 8cyl in a 61 4x4 C-20 pickup. Unfortunatly the 4x4 uses a obsolete front motor mount so I have robbed a cross member from a '68 truck. Now the question... I figured out the center of the mounts on the crossmember have to be 16" from the face of the bell housing, but how to I determine how high up on the frame to weld? ( elevation) I figured I could use the dimension of the distance from the center of the crank to the center of the motor mount on the block, ( I know the centerline from trans input shaft to the front of the truck by using a laser pionter) if any one knows this measurment..... Thanks in advance

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 11:18 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.