Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Engine> Piston Identification and Specification
User Name
Password
lost password?   |   register now

Thread: Piston Identification and Specification Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
12-14-2008 04:09 PM
ap72 You could always just measure all the critical specs too... Don't need the part number if you know all the dimenions, the alloy composition would be unknown (could guess off of a penetration test) but for most engines piston volume, bore size, ring specs, and comp ht. are all you need.
12-14-2008 03:51 PM
Jobob Jr
Piston Identification and Specification

Thanks for the response, i've got a few sets of pistons that have been laying around the shop for some time and would like to put them to some sort of use besides as landfill
12-14-2008 02:50 PM
ap72 KB has a good site for reference too- but only for their pistons.
12-14-2008 02:46 PM
327NUT I didn't google any of this but "Wishful Thinking" is probably right, there's most likely a million piston part numbers...just for sbc's. I would hit the Federal Mogul/Speed Pro web site just to get an idea.
12-14-2008 09:16 AM
Jobob Jr
Piston Identification and Specification

Looking for a site that lists general information on engine pistons by Part number, Bore size, Compression ratio, Dish or Dome size, or for that matter, any other means of identification. Aside from going to each of the manufacturers sites, i'm hoping someone has a general listing of some sort. Wishful thinking, no doubt.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 10:49 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.