Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic -- Hot Rod Forum

Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Engine> oil galley plugs
User Name
lost password?   |   register now

Thread: oil galley plugs Reply to Thread
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:
Please select your insurance company (Optional)


Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.

Additional Options
Miscellaneous Options

Topic Review (Newest First)
02-04-2009 05:21 PM
63,68,70 muscle Thanks for the response. I took out the trany, clutch and related parts. previously the plugs were the problem because one of them wasn't run in far enough. That issue has since been fixed. I found out this particular leak is actually coming from the very corners of the oil pan gasket at the bearing cap. That's a new project. thanks again
01-30-2009 03:50 PM
MorrisonLC Those are the little threaded ones, like about a 1/8" NPT? Did you replace them with new plugs when you built it? Are you using a good quality USA made plug with no thread flaws? Use non-hardening Permatex, you should have no problems. You're not just gooping sealant over the top of the plug, right?
01-30-2009 03:40 PM
63,68,70 muscle
oil galley plugs

Help! I've got a stroked 289 to a 349 high volume oil pump, and leaks. I've sealed the oil plugs on the back of the block with gasket sealer. Two are doing fine, but one keeps leaking at high RPM. Im getting tired of pulling the trans, clutch, and everything else related. What will seal this thing up? I start tearing down Sunday.......again. Thanks

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

All times are GMT -6. The time now is 11:20 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2017 DragonByte Technologies Ltd.
Copyright 1999 - 2012. All Rights Reserved.